Hi Jim, 1. When using black level calibration (automatic method), CDAC and FDAC enable mode should be used after power up calibration and FDAC only mode during normal scan operation. Is my understanding correct. Can Auto black loop Enable in register BLKCLP_CTL0 (0x23 bit 2) kept HIGH always. 2. When using white level calibration (automatic gain control), AGC_ON bit in register AGC_CONFG (0x28 bit 0) is set using serial interface(AGC_ONB is always HIGH. AGC_ONB polarity selected as active low). Should we write AGC_ON LOW from serial interface after white loop is complete or will it get cleared automatically after white loop is complete. Regards Prasanna
↧