Hi TISL, How are you? Looks like the customer is not running LMK yet, right? Could you please help the customer running the following simple verification? 1) please move two jumpers of the connecter J42 to "XTAL-SE" side (i.e. position closer to the Y1 Osc). That Y1 on-board OSC is 40MHz crystal Clock (external clock to AFE5832 's input clock pin). 2) also please connect a jumper to J41. Then in this case, please try run your TSW1400 GUI again. Hopefully you can see a correct output waveform (to Channel 1) coming from your signal generator. Thank you! Best regards, Chen
↧