Hello, I was unsuccessful in establishing communication between the boards. My logic analyzer detects proper data on the MOSI line, but no response from the MISO line. I am forced to conclude that there is some kind of mismatch in the jumper configurations of the ADS1298RECGFEPDK. I am currently only trying to read the Device ID by writing the specified value to the register. For this should i leave JP5 of the Eval board open and initialize a PWDN sequence? I have also configured the device for using internal oscillator using JP18 and JP19. According to the ADS1298R datasheet, in the Application information section, there is a flowchart for the initial flow at power-up. Does this require to be followed as well to read device ID?
↧