Hello Hooman, First of all I want to thank you for your support and concern. I have listed down some of my questions: I'm using sensor in Mode 3 but as I have already said that I don't need to turn on the RGB lamps of the sensor because in my application sensor has to detect the x-rays passed by a small body organ and gives electric signal. My sensor has 3 inputs for RGB lamps so should I still connect SH1, SH3 and SH4 to these sensor input or not? Yes I'm using CMOS data output in this case SH2/CLKOUT should be connected to the FPGA as a DATA clock. So now I have to connect SH5 pin to the sensor SP pin which controls wen each new line of scan begins and end right? and PHIA1 to the CP. I*m using master timing generation mode. Why resistors should be used with the clock? What is the difference between PIXEL CLOCK and ADC CLOCK and which one should I need and configure if I used a sensor at 5MHz? PIXPHASE? VCLP pins sets the reference level voltage which will be detected with the CLAMP pulse? What is SH interval and its different states I didn't understand it. How to configure registers via serial interfacing? I know how busy you are, so I really appreciate in advance the time you have to give me. As this field is new to me so I has a very hard time understanding and remembering the concepts. Kind Regards, Martin
↧
