Forum Post: RE: does the tx810 have bias current input internal pulldowns or...
David, the TX810 requires three external pulldown resistors of 10k-20k.
View ArticleForum Post: RE: AFE for ICX659ALA image sensor
Hi Sankar, Here my E-mail ID - bala.murugan@industeqsite.com. Kindly provide a suitable solution to find an AFE for the image sensor. regards Bala
View ArticleForum Post: RE: VSP5612 register assignments
Sorry for the delayed reply. The register map will be provided to customer after a NDA is signed. Please note that the VSPxxxx devices are recommended for high volume applications. regards Sankar
View ArticleForum Post: RE: VSP01M01/2
Sorry for the delayed reply. There is no reference design available. However, we can provide support to the customer (to build the solution), provided the volumes are high. Please note that the VSPxxxx...
View ArticleForum Post: RE: Do we have any reference designing about VSP01M01? such as...
Sorry for the delayed reply. There is no reference design available. However, we can provide support to the customer (to build the solution), provided the volumes are high. Please note that the...
View ArticleForum Post: RE: VSP5612 Register are not specified
Sorry for the delayed reply. The register map will be provided to customer after a NDA is signed. Please note that the VSPxxxx devices are recommended for high volume applications. regards Sankar
View ArticleForum Post: RE: VSP5612 SPI Reg Map description？
Sorry for the delayed reply. The register map will be provided to customer after a NDA is signed. Please note that the VSPxxxx devices are recommended for high volume applications. regards Sankar
View ArticleForum Post: RE: AFE5808 SPI limits
Haha. No Problem. Thanks for reading in detail, though
View ArticleForum Post: What's Digital Ground and Analog Ground Short/Common at one place...
Dear All, Would you please give me an idea about what's digital ground and analog ground short/common at one place only? Does the supply power ground to both analog and digital ground count one? Here...
View ArticleForum Post: RE: Availability & Substitutes for CCD TC237B
We are in similar but a slightly less desperate situation, we we're given the EOL, and placed our lifetime buy, but it was only partly fullfilled. We have found a replacement part in the CMOSIS...
View ArticleForum Post: RE: How to configurate VSP5622?
Hi, Pls contact the nearest TI sales office. They will be able to help you. regards Sankar
View ArticleForum Post: RE: AFE5807 - question about integrated ADC
Damian, The AFE5807 and AFE5808A both have a maximum Resolution of 14-bit. However, the AFE5807 is a lower-power version of the AFE and it defaults to 12-bit mode by truncating the 2LSBs. You may also...
View ArticleForum Post: RE: ADS5263EVM and TSW1250
Hi Guglielmo! Yes, now it looks fine, for both the ramp and the sine wave! And the FFT makes sense. A lot of thanks! Thomas
View ArticleForum Post: RE: Single Supply OpAmp withstand negative voltage on input?
Current at the Input Pin +/- 10mA ... AND... Voltage at the Input/Output pin (V+) + 0.3v, (V-) - 0.3v ... is incorrect based on the posted response "limit the input current to 10mA or less with a...
View ArticleForum Post: RE: AFE0064 linearity
Hi, Please mention the following in relation to figure 2 of the datasheet 1) What is the value of t3? 2) What is the clock speed? 3) Are you in simultaneous mode? 4) I am assuming the time delay...
View ArticleForum Post: RE: LM96550 (or 96551) pulsar
Evgeniy, The instantaneous current for each channel clamps at 2A. This means that you can run 8 channels at 50V simultaneously. The specs in the data sheet do expect a 2kohm load however. So 50/50 is...
View ArticleForum Post: RE: AFE5805 or LM96511
Valeri, For the TX810, I can recommend the TPS79633DCQR. Thanks, Chuck Smyth
View ArticleForum Post: TWS1250EVM & AFE5805EVM - parallel data on header
Hello, the TWS1250EVM user guide says the LVDS data is continuously converted to a single-ended bus and output on headers. But then the next sentence starts talking about a FIFO. My question: If I use...
View Article