Hi Charles,
Thanks for your answer,It's really very import for me~Thanks again.
Wrong power will burn the Board.May I ask more detail??
- The +/-50V, +/-10V, 3.3V & sub are used by the LM96551 (pulser).
How to connect +/-50V, +/-10V, 3.3V & sub ?? Are all of them working at the same time? How to define different Freqency??
How many channels of powersupply need to use?? And the powersupply current setting ?? mA or A ??
- The +/-5V, & sub are used by the LM96530 (T/R switch).
The sub is used again.What is the seting on the powersupply?? If no using ,is it can be ture off.
- The 3.3V & 1.8V are used by the LM96570 (beamformer).
I don't understand the powersupply setting.
- For CW mode, the supply current can read reach 300mA.
SPEC:Continuous-wave (CW) applications are supported for low power consumption down to VPP = -VNN = 3.3V with Mode =HI. What is the meaning?
Could you send me pictures which are the banana connecters(pulser /TR /Beamform) on the powersupply?? And what is the powersupply setting ? ex: +50 sub -50 with ??mA
Is turn of sequence /turn of sequence following pulser spec??
Because the link http://www.ti.com/tool/tx-sdk-v1 is no detail technical document about this tool kit.So I ask so many question.
Thanks so much~
Have a good time~
Email: davincij2010@gmail.com