Part Number: ADS8555 Hello,Dale Below is the situation of the customer. >1. Can the customer get the correct out data without any change Control Register (default value)? Since it is SPI, I think whether data will be needed when clocking out, At this time, what should be input to SDI? >2. Keep software mode at the end of Flow 1 until the end of Flow 2, and check the data on the SDO in Flow 2 again. The result is always 7FFE. >3. Read the default value of Control Register after power up the device, check if it is 0x000003FF. Since C17 = READ_EN is in the register, When reading it, at least C17 needs to be 1 Is it not? In other words, do you think that it will not become 0x000003FF? Best,regards, DDdoor
↧