Part Number: AFE4300 Hello, I am using afe4300 with stm for bcm and weight measurements. I am using the application circuit given in section 8.1.1 in afe datasheet on the page number 30. I am putting known impedance values in place of Rbody and noting down adc values.But after taking readings once. After a day I came back and measured the same resistance values but found that i was getting very different adc values for the same. I dont understand how this can happen. Is there something to do software wise to stop this from happening? I cannot depend on any adc values for a best fit equation because they are so inconsistent. Any assistance will be appreciated. Link to afe datasheet : www.ti.com/.../afe4300.pdf Thanks And Regards Abhinav Nagaraj
↧