Hi sir,
Thank you for being informative.
I am facing error in GUI getting connected to the hardware set up. And the power supplies are vpp(50v)=15v, vnn(-50v)=-15v, vdd=10v, vdn=-10v ,vsub=-20v, 3.3v, 1.8v ,-5v ,5v supplies to phoneix connectors pins of Tx_sdk_v1 board.
Note : since i dont have +/-50v power supply currently ,so for start up I am trying to generate +/-15v pulses at pulser. by giving power supplies as mentioned above.
below images.rar shows images of my hardware setup, please review my hardware setup, I am sure that I followed the manual. But I am facing error while connecting GUI to hardware shown in last image.
Please help me to generate +/-15v pulses, and let me know If I am doing any mistake.
(Please visit the site to view this file)
thank you so much.
regards,
chandu.