Hello Jim, I have attached an updated Registers configuration file, please have a look. Today I configured the registers with this sequence while +INCLK was applied continuously and I get some sort of clock pulses on the PHIA1 and PHIB1 but its not correct (see images below) because I have set the duty cycle to 50% but the wave form is random. Kindly guide me where is the problem in the registers data or in the circuit. I have also configured the SH1 but didn't get any output from this pin. One more thing I want to know that when I switch OFF the circuit and turn it ON again, all the registers data get erased and I have to configure all registers again. Is it normal? Yellow is the INCLK and Blue waveform is the PHIA1 and PHIA2. (Please visit the site to view this file)
↧