Hi Hooman, Thanks for your detail answer. For my CIS sensor SP signal, I set only one SH state length i.e SH State 0 on Page 3 Register 0 and all other state lengths should be zero because I need signal to go high only once. Furthermore I select SH1 to go high at SH state zero (Page 5 Register 0 Bit 0 = 1) and connect this SH1 to my CIS SP signal pin. This is Okay? My CIS sensor is getting CP from PHIA1, for this purpose I did following configuration: INCLK = PIXCLK = 5MHz Page 6 Register 1E Bit 4 = 0 (for 5MHz PHIA) But I don’t understand how should I configure registers 0 to 5 on page 6 for PHIA and what are their functions? You told me to configure them as well in your last message. There is a description about CE pin (chip enable) on page 84 should I connect it to the GND? Regards, Martin
↧