Forum Post: RE: ADS131E08: ADC offset voltage across channels
Hi, I have tried your recommendation, but this didn't solve my problem yet. Could you please advice more?
View ArticleForum Post: ADC128D818: When will address pins A0 & A1 (Pins 7 & 8) be...
Part Number: ADC128D818 In your data sheet there are examples of connecting A0 and A1 to GPIO of some µC. In some posting I read that A0/A1 are sampled during POR. Are there any additional conditions...
View ArticleForum Post: RE: ADC128D818: When will address pins A0 & A1 (Pins 7 & 8) be...
Examples in data sheet under "9.3 System Examples": Figure 38. Typical Analog Input Application
View ArticleForum Post: RE: ADS1293: ADS1293 3-Lead ECG noise
Hi Alexander We find ID register error is tool should be click read icon at register 0x40, if we click read icon the ID register is 0x01. as below waveform are disable pace output (register 0x17h...
View ArticleForum Post: ADS1299EEGFE-PDK: Where can I download the ADS1299 software?
Part Number: ADS1299EEGFE-PDK In the PDF document above, where can I download the software(ads1299-eeg-fe-1.0.0.exe)? This link does not work though - www.ftpstatus.com/file_properties.php Cheers.
View ArticleForum Post: RE: ADS1299: ADS1299EEG-FE 10 channel bias and reference connection
Forgive me for repeating my question. I have attempted to do as you suggested, but the its still not working. I have attached a picture of the setup. The orange wire connection to JP25[2] is the bias...
View ArticleForum Post: ADS8634: Input reference temperature drift data
Part Number: ADS8634 Hi, Could you provide the data of temperature vs internal reference voltage for our reference? I would like to know information during 25℃～50℃. Best Regards, Kuramochi
View ArticleForum Post: RE: ADS1114: I2C interface to coexist with PMBUS
Zhipei, I've never run the ADS1114 with other PMBus devices on the same bus. However, PMBus is similar to I2C and much of the communication would be functional. I did come across this post about I2C...
View ArticleForum Post: RE: ADS1226: Resolution at different mode
Vincent, Like many other Delta-sigma type ADCs, the ADS1226 trades speed for noise performance. Both modes will report data with 24-bits. High-Speed mode runs nominally at 100SPS, but has an RMS noise...
View ArticleForum Post: RE: ADS1298R: Pacing pulse inhibition and test signal problem
Hi Rayan， Thank you for your reply. 1. does this mean if it detects pacing pulse, we can change the gain setting to make it work properly? 2. Attached the image, I am not sure if it shows correctly...
View ArticleForum Post: RE: ADS1226: Resolution at different mode
Hi Joe, Got it, thanks very much for your prompt response. I will update customer and let you know if customer has further question. Vincent
View ArticleForum Post: RE: AFE4405EVM: The eval board stopped working. Software issue
You may close this thread. I tried another eval board and that works fine. Thus, no SW issue on my computer. Something is fishy with one of the evaluation boards that I ordered.
View ArticleForum Post: RE: ADS131E08: ADC offset voltage across channels
Mahlet, Ryan was correct in that you had also set the GAINn[2:0] to 000 and it must be set to 001 to 110. In the end, what did you set these gain to? This would have been the sequence where you had...
View ArticleForum Post: RE: ADS8900B: What is the use of pattern registers?
Hi Keith, I hope I understood your explanation. If we set any pattern in pattern register and our DATA_VAL=1b, then our output will be AND'ed with the pattern register and it will stored in ODR. This...
View ArticleForum Post: RE: ADC128D818: When will address pins A0 & A1 (Pins 7 & 8) be...
Thanks for the time being, Joseph. I've ordered some samples; we'll see. Regards, Peter
View ArticleForum Post: RE: AFE4405: Run a diode laser with AFE4405
Hi Prabin, to run a laser is not the issue. The problem is to monitor the light level using the built in photodiode. I have tried to connect the laser photo diode (PD) as described by the attached...
View ArticleForum Post: ADC12DJ2700EVM: How to get many data using TSW14J57EVM Data...
Part Number: ADC12DJ2700EVM I am using ADC12DJ2700EVM and TSW14J57EVM to capture analog data with sampling rate of 5.4 GHz. I want to get a lot of data above 65535, but the software for the data...
View ArticleForum Post: ADS1292: If ADS1292 EVM soft can operate in Win 10？
Part Number: ADS1292 I just operate ADS1292 EVM software in Win10, i find that the software cannot detect the device, how can i use it in Win 10?
View ArticleForum Post: AFE4300: The test resistance of the AFE4300 at 500KHz
Part Number: AFE4300 Dear TI experts， Excuse me, is there any data about the test resistance of the AFE4300 at 500KHz? It's a multi-frequency body fat test case, and the customer thinks that it’s...
View Article